Our store is under maintenance till 2/18. All website information and checkout are still open, but order fulfillment will resume after 2/18. Sorry about any inconvenience caused by this.

E3D SpoolWorks Scaffold Filament

Availability: In stock


Quick Overview

* Required Fields


With this product, you earn 57 loyalty point(s). 57 points = $2.85.


Scaffold is a water-soluble and break-away support filament that actually works.

Scaffold offers total design freedom, helping you to create complex geometries and complete functioning mechanisms in a single print (with no worries about overhangs!). Part of E3D’s SpoolWorks range, Scaffold works best with our Edge and PLA filaments.


  • Can be broken away or dissolved from prints in normal tap water
  • PVA/PVOH-based but easy to print with low viscosity
  • Exhaustively tested for exceptional quality
  • Lower heat degradation and easily purged from nozzles
  • Designed for perfect compatibility with SpoolWorks Edge
  • Shipped in a re-sealable bag with desiccant for exceptional dryness

Advised print settings:

  • Print Temp: 215C
  • Bed Temp: From 20C to 55C ideally, but will cope with bed temperatures as high as 110C
  • Print Speed: ~50mm/s

Cautionary notes and advice.

  • You will need to create specific slicer settings to make the best of Scaffold.
  • You will need to create specific slicer settings to make the best of Scaffold.
  • Scaffold needs to be kept dry, use the supplied resealable bag.
  • Scaffold will degrade if kept for extended periods in a hot nozzle. Do not allow Scaffold to rest in the nozzle at temperature or you risk clogging and damaging the nozzle.
  • Please read the documentation in order to use Scaffold at it's full potential
  • Note: All 3D printers are unique so adjust settings to taste!