RUMBA Board (DRV8825)

Availability: In stock

$129.95

With this product, you earn 130 loyalty point(s). 130 points = $6.50.

Quick Overview

RUMBA all-in-one 3D printer motherboard with 5 DRV8825 drivers.

More Views

  • RUMBA Board (DRV8825)
  • RUMBA Board (DRV8825)

Details

The RUMBA (R.eprap U.niversal M.ega B.oard) control board provides a fully integrated all-in-one solution. It comes with a set of 5 DRV8825 stepper drivers, which run cooler than A4988 drivers and can handle higher current up to 2A and 1/32 microstepping.

Features:

Fully integrated all in one solution

- Arduino 2560-R3 compatible (works with Sprinter, Repetier, Marlin out of the box) (easy to change/flash firmware for end user)
- ATmega16U2 (with enhanced firmware) for high speed USB serial connection (up to 2MBit)

 

Universal Power

- can be used with 12V-35V for motors / heated bed
- integrated high precision power regulators for 12V (FAN/Light/...) and 5V (ATmega2560/Logic)
- power input selector for ATmega/logic (stand alone or power from USB)

 

Easy DISPLAY + SD-CARD connector

- RepRapDiscount SmartController compatible pin header on board

 

Up to 6 motor driver ports with micro stepping

- TRIPLE extruder, or
- DUAL Z driver and DUAL extruder, or ....?

 

5x temperature ADC connectors

- e.g. 3x extruder thermistor + 1x heated bed thermistor + 1x chamber thermistor

 

5x PWM capable power mosfet outputs (3 with voltage selector for MainPower/12V)

- e.g. 3x (MainPower) extruder heater cartridge/power resistor + 1x (12V) fan + 1x (12V) light

 

1x PWM capable power mosfet with extended cooling area for heated bed

6x end stop connectors with power supply

- Xmin/Xmax/Ymin/Ymax/Zmin/Zmax
- can be used for mechanical, opto, hall, ... end stops

 

Screw terminals *and* pin header for easy motor connection

- can be used with existing 4 pin Molex plug on motor cable
- easy to attach cables without plug

 

USB connector and pin header

- pin header is useful when mounting in a small box

 

Power and ALL unused pins available on EXP-3 feature connector

- +5V and +12V
- 2x ADC
- 2x PWM I/O
- 4x I/O
- I2C

 

Full JTAG support

- JTAG can be used during full operation (no shared pins)
- easy to develop/debug new or optimized firmware using Atmel Studio

 

More information:

- RUMBA wiki: http://reprap.org/wiki/RUMBA